Sponsors:



Most Popular:

  258 Carter BBD Idle Problem
  42re Transmission
  AMC 20 Axle
  AMC 242 4.0l Engine
  AMC 258 I6 Engine
  AMC 304 V8 Engine
  AX 15 Transmission
  AX 5 Transmission
  Axle Upgrades
  CJ-5
  CJ-7
  Dana 30 Axle
  Dana 44 Axle
  Front Dana 44 Axle Swap
  Jeep CJ Gauge
  Jeep Engine Upgrades
  Jeep Tires
  Jeep Transmission
  Rear Dana 44 Axle Swap
  Transmission Conversion

IH T-18

by Terry L. Howe


IH Trans

T-90
BW-11
T-18
T-15D
TF727
T-19

International

Transmissions
Transfer Cases

The T-18s was used in International Havevester trucks from the mid 60s until the mids 70s. They all tend to have long input shafts compared to the Jeep and Ford T-18s. All of the T-18s used in the Scout 800 and Scout II are close ratio T-18s with a first gear around 4:1. It is an excellent transmission, but it doesn't have the low first off-roaders want. Other IH trucks do use wide ratio T-18s.

An advantage of the IH 4WD T-18s is most of them were mated with the Dana 20 transfer case. The Dana 20 used in Scout trucks uses the same bolt pattern and input gear as most of the Dana 20s used in Jeep trucks. The transmission to transfer case adapter for the Dana 20 used in IH trucks is short like the adapter used in Jeep trucks. Rebuilding one of these transmissions with a Ford or Jeep input shaft may be a way of getting a low buck T-18 in your Jeep.

Like the versions of the T-18 used in other makes of trucks, IH T-18s have a casting number of 13-01 or T-18 on the drivers side. All IH T-18s have reverse out and up.

Last modified Wednesday, 01-Dec-2010 08:13:05 MST


[ Jeep Tech Main Page | Terry's Jeep Page ]

Copyright © 2001, 2000, 1999, 1998 JEEPTECH.COM
All Rights Reserved, All content with exception of private works and
corporate trademarked logos are property of Jeeptech.com




Leave a Comment:
Name:

(Not a Spam Bot)

Comments: